Tool change in estlcam12/17/2022 ![]() The ability to specify that square corners are required is another powerful feature. This can significantly improve the finish on the cut-edge. If this allowance is given, then all but the last pass will be over-cut by the specified allowance with the final pass being the only pass which cuts to the actual edge of the part. The number of passes on a cut can be edited very precisely to allow very thin final cuts or to individual add or remove particular cut depths.Ī separate last pass allowance can be specified for the last pass in a profile toolpath.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |